Y Tubing Connector
- Watercooled Pi
- Aug 28, 2015
- 1 min read
I’ve added these Y tubing connectors to my “to-buy” list.
In my previous post, I mentioned that I would actually try connecting the pumps in parallel rather than series. I’ve done a bit of research and found that pumps in parallel will create a higher flow rate, and pumps in series will create higher head or pressure. These Y tubing connectors allow me to try both systems to see which will be the best for my needs.
Like the water blocks and the thermal pads, they have been sourced from Aquatuning Australia, simply because there is no other website that sells the tiny water blocks I’m using and I wish to save on postage by buying everything from a single site. I will, however, check my local hardware store if I get the chance to see if I can get anything similar.
Comments